Table of Contents
Advertisement
Mounting the
Magnalock and aligning
to the strike plate
1
SLIDE the Magnalock assembly to fully engage
the lock chassis to the mounting bracket. Install
one of the three screws through one of the top
chassis holes and into the mounting bracket to
temporarily secure the Magnalock (see Diagram 16).
2
SLIDE the lock forward or backward so
that the entire face makes contact with
the strike plate on the closed door.
3
MARK the back edge of the mounting bracket
at each end and remove the Magnalock
from the bracket (see Diagram 17).
4
ENSURE that the mounting bracket
aligns with the marks and TIGHTEN the
mounting screws (see Diagram 18).
5
USING THE BRACKET AS A TEMPLATE, DRILL pilot
holes as necessary, then install and tighten the four
(4) final mounting screws (see Diagram 19).
FOR HOLLOW METAL DOORS: DRILL 3/16" holes and
use #12 x 1-1/2" screws.
FOR WOOD DOORS: DRILL 7/32"
holes and use #14 x 3" screws.
6
RETURN the Magnalock to the bracket and secure
the chassis to the bracket with three (3) screws.
Installing the
wall-mounted switch
1
ASSEMBLE the cylinder and switch to the wall-
mounted key switch plate (see Diagram 20).
2
MARK the corners for the mounting device
at the desired locations on the wall and
create a cut-out (see Diagram 21).
3
INSERT the mounting device into the cut-
out and fasten it in place with a Phillips
screwdriver (see Diagram 22).
4
MAKE the wire connections and install the
key switch plate using a flat-tip screwdriver
and two 6-32 screws (see Diagram 23).
Diagram 16 Mounting the
Magnalock to the bracket
Diagram 18 Tightening
the mounting screws
Diagram 20 Assembling
the key switch plate
Diagram 22 Installing
the mounting device
Diagram 17 Marking the back
edge of the mounting bracket
Diagram 19 Installing the
final mounting screws
Diagram 21 Marking the wall cut-out
Diagram 23 Installing the key switch
5 of 12
Advertisement
Table of Contents
