Advertisement
4.3 Drilling holes for drawer runners:
Drawer pull-outs, regardless of whether they are telescopic slides with
partial or full extension technology, are manufactured and delivered with
standardised drill holes.
The 32mm system can be found in all current systems. It is advisable to
first create a row of holes parallel to the front of the body.
1. Creation of a row of holes parallel to the front of the body. Proceed as
described in point 4.1. Pay attention to the required distances of the first
or last hole to the bottom or top panel.
2. To cutthe cross rows, rotate the stencil by 90 degrees. Use the two outer
5mm bolts to fix the template in the existing hole line
3. If it is not yet clear which hole positions of the telescopic slides you
are using, it is recommended to drill a continuous cross row.
4. Repeat the procedure for each pull-out position.
Fig. 6
The 5mm bolts give the stencil a
firm hold on the workpiece.
Nevertheless, the stencil must
always be firmly fixed to the
workpiece by means of clamps.
One-hand clamps are easy to
use and speed up the work
many times over.
Advertisement
