Advertisement
4.2 Extension of existing hole lines:
1. With the sautershop MFS-3202 template, you have the possibility of easily
extending 5mm hole lines.
2. To do this, place the template on the hole line and position it with a 5mm
bolt hole over an existing hole in the existing hole line.
3. Insert the 5mm bolt into the 5mm hole to fix the position of the existing hole
line.
4. When the hole is fixed, the parallel alignment must be carried out. If the
existing row of holes has been created with a standard spacing, the
corresponding spacer bolts can also be used here as described above. If
the spacing is not in an existing stop dimension, the alignment must be
carried out by hand and using a meter scale. For this purpose, the distance
is first taken at the fixed point and adjusted at a remote point on the
template.
5. As can be seen in the picture above, this can also be done in parallel
alignment. You have countless possibilities to align the template to existing
drill holes.
6. After correct adjustment, the stencil must be fixed again with two screw
clamps.
7. Finally, the hole line is cut.
Fig. 5
Using the existing 5mm
bolts, existing rows of holes
can be used as a starting
point for extending holes.
This makes it very easy to
create endless rows
regardless of how long the
material is!
Advertisement
