Specifications; Terms Of Use; Working With The Device - K&S BASIC KSB 30i S Owner's Manual

Model
Voltage, V
Max Power, kW
Nominal Power, kW
Frequency, Hz
Current, A (max.)
Outlets
Engine start
Fuel tank volume, l
Noise level L (7m)/L , dB
PA WA
Output 12V, A
Engine model
Engine cylinder volume cm
Crankcase volume, l
Engine type
Engine power, hp
Power factor, cos φ
Dimensions (L*W*H), mm
Net weight, kg
Protection class
To ensure reliability and increase the engine service life, peak powers may be slightly limited by circuit breakers.
The optimal operating conditions are ambient temperature of 17-25°C, barometric pressure of 0.1 MPa
(760 mm Hg), and relative humidity of 50-60%. Under these environmental conditions, the generator can provide
maximum performance in terms of the declared specifications. In the event of deviations from these environmental
indicators, the generator performance may vary.
Please note that in order to preserve the long service life of the generator, continuous loads of more than 80% of the
nominal power are not recommended.
When starting operating the generator, it's recommended to ground it. Before starting the unit, remember that the
total power of consumers connected should not exceed the rated capacity of the generator.
IMPORTANT!
OIL LEVEL INDICATOR OIL LEVEL INDICATOR
When the oil level falls below the level required for operation, the oil level indicator lights up, and then the engine
stops automatically. The engine will not start until oil is added.
3
Nominal voltage tolerance – max. 5%
Make sure the control panel, louver and the inverter bottom
side cooling well and without chips, mud and water come in. It
may damage the engine, inverter or alternator if the cooling vent
blocked.

SPECIFICATIONS

KSB 30i S
manual
12V/8.3A
KSB 240i
gasoline 4 stroke cycle engine
480*285*420

TERMS OF USE

WORKING WITH THE DEVICE

www.ks-power.de/en
3
230
3.0
2.7
50
13
2*16А
4.0
70/95
142.6
0.35
4.2
1
23
IP23M
4
5
| 3