Related Manuals for K&S BASIC KSB 21iS
Summary of Contents for K&S BASIC KSB 21iS
- Page 1 OWNER’S MANUAL Please, read this manual carefully before use! Inverter Generator in Soundproof Housing KSB 21i S KSB 30i S KSB 40iE S...
- Page 2 INTRODUCTION Thank you for your purchase of K&S Basic products. This manual contains a brief description of safety, use ® and debugging. More information can be found on the official manufacturer’s website in the support section: konner-sohnen.com/manuals You can also go to the support section and download the full version of the manual by scanning the QR code, or on the website of the official importer of K&S Basic products: www.konner-sohnen.com ®...
- Page 3 The generator should be used as an IT or TN system based on the application. Earthing and additional protective measures such as insulation monitoring or protection against accidental contact IMPORTANT! (residual current device) must be provided based on the applica- tion and the system used.
- Page 4 MAIN OVERVIEW MODEL KSB 21 MODEL KSB 21i i S S 1. Transport handle 6. Fuel tank cap air vent 2. Control panel 7. Spark plug service cover 3. Ventilation grille 8. Silencer 4. 3-in-1 switch 9. Service cover (for motor oil change) 5.
- Page 5 8. Ventilation grille 9. Muffler 10. Carburetor 11. Air filter 12. Spark plug 13. Maintenance cover (for motor oil change) MODEL KSB 30 MODEL KSB 30i i S CONTROL PANEL S CONTROL PANEL MODEL MODEL KSB 40 KSB 40iЕ iЕ S S CONTROL PANEL CONTROL PANEL 1.
- Page 6 SPECIFICATIONS Model KSB 21i S KSB 30i S KSB 40iE S Voltage, V Max Power, kW Nominal Power, kW Frequency, Hz Current, A (max.) 14.3 16.5 Outlets 2х16А 2х16А 2х16А Engine start manual manual manual/electric Fuel tank volume, l LED display multifunctional* Noise level Lpa(7m)/Lwa, dB 62/87...
- Page 7 Make sure that the control panel, the blinds and the underside of the inverter are well cooled and protected against the ingress IMPORTANT! of small solids, dirt, and water. Improper operation of the cooler can cause damage to the motor, inverter or alternator. WORKING WITH THE DEVICE OIL LEVEL INDICATOR OIL LEVEL INDICATOR...
- Page 8 CHECK BEFORE GETTING STARTED CHECKING THE FUEL LEVEL CHECKING THE FUEL LEVEL 1. Unscrew the fuel cap and check the fuel level in the tank. 2. Fill the fuel tank to the fuel filter level. 3. Tighten the fuel cap securely. 4.
- Page 9 This material is for informational purposes only and does not constitute a manual for installing the equipment or connecting it to the mains, but we strongly recommend that you read the instructions below. Equipment connection must always be carried out by a certified electrician responsible for the installation and electrical connection of the equipment according to local laws and regulations.
- Page 10 5. In this position: Fuel system is on. Ignition circuit is on. Battery power is on Air choke closes and generator is ready to start with a cold engine. (If the engine is warm, immediately turn the 3-in-1 switch to the “ON” position). 5.1.
- Page 11 generators ensures total rated output power of these generators. When the generators are connected in parallel, the power loss is 0.2 kW of the total rated power that can be obtained. During parallel operation, the ECONOMY MODE switch must be in the same position on both generators. 1.
- Page 12 - If the generator often operates at high temperature or high load, the oil should be replaced every 25 operating hours. - If the engine often runs in dusty or other harsh conditions, clean the air filter every 10 operating hours. - If you missed the maintenance time, perform it as soon as possible to save the generator engine.
- Page 13 FUEL FILTER Never use gasoline while smoking or in the immediate vicinity of IMPORTANT! an open flame. 1. Remove the fuel tank cap and fuel filter. 2. Clean the filter with gasoline. 4. Replace the fuel tank cap. 3. Wipe the filter and replace it. Make sure that the fuel tank cap is tight.
- Page 14 7. Reinstall the oil drain plug and gasket. 8. Refill the oil to a proper position and tighten the oil gauge. 9. Clean the oil guide groove and Install the cover of generator back. Do not tilt the generator when topping up engine oil. This can cause the crankcase to overflow and damage the engine.
- Page 15 ANNEX Fig. 1 MODEL KSB 21 MODEL KSB 21i i S S MODELS KSB 30 MODELS KSB 30i i S, S, KSB 40 KSB 40i i E S E S Fig. 2 MODEL KSB 21 MODEL KSB 21i i S S MODELS KSB 30 MODELS KSB 30i i S, S, KSB 40 KSB 40i i E S E S...
- Page 16 Fig. 3 MODEL KSB 21 MODEL KSB 21i i S S MODELS KSB 30 MODELS KSB 30i i S, S, KSB 40 KSB 40i i E S E S Fig. 4 MODEL KSB 21 MODEL KSB 21i i S S MODELS KSB 30 MODELS KSB 30i i S, S, KSB 40 KSB 40i i E S E S...
- Page 18 CONTACTS Deutschland: DIMAX International GmbH Flinger Broich 203 -FortunaPark- 40235 Düsseldorf, Deutschland www.koenner-soehnen.com Ihre Bestellungen Ihre Bestellungen orders@dimaxgroup.de Kundendienst, technische Kundendienst, technische Fragen und Unterstützung Fragen und Unterstützung support@dimaxgroup.de Garantie, Reparatur und Garantie, Reparatur und Service Service service@dimaxgroup.de Sonstiges Sonstiges info@dimaxgroup.de Polska: DIMAX International...