Specifications; Terms Of Use - K&S BASIC KSB 12i S Manual

Model
Voltage, V
Max Power, kW
Nominal Power, kW
Frequency, Hz
Current, A (max.)
Outlets
Engine start
Fuel tank volume, l
Noise level L (7m)/L , dB
PA WA
Output 12V, A
USB-Outputs
Engine model
Engine cylinder volume cm
Crankcase volume, l
Engine type
Engine power, hp
Power factor, cos φ
Generator parallel socket
Dimensions (L*W*H), mm
Net weight, kg
Protection class
*Fuel consumption depends on many factors, such as load, fuel quality, season, altitude, technical condition of the
generator.
To ensure reliability and increase the engine service life, peak powers may be slightly limited by circuit breakers.
The optimal operating conditions are ambient temperature of 17-25°C, barometric pressure of 0.1 MPa
(760 mm Hg), and relative humidity of 50-60%. Under these environmental conditions, the generator can provide
maximum performance in terms of the declared specifications. In the event of deviations from these environmental
indicators, the generator performance may vary.
Please note that in order to preserve the long service life of the generator, continuous loads of more than 80% of the
nominal power are not recommended.
When starting operating the generator, it's recommended to ground it. Before starting the unit, remember that the
total power of consumers connected should not exceed the rated capacity of the generator.
IMPORTANT!
3
Nominal voltage tolerance – max. 5%
Make sure the control panel, louver and the inverter bottom
side cooling well and without chips, mud and water come in. It
may damage the engine, inverter or alternator if the cooling vent
blocked.

SPECIFICATIONS

KSB 12i S
230
1.2
1.0
50
5.2
1*16А
manual
2.5
62/87
12V/5A
5V/1A, 5V/2.1A
KSB 90i
57
0.33
gasoline 4 stroke cycle engine
1.8
1
+
460*275*435
11.5
IP23M

TERMS OF USE

www.ks-power.de/en
3
4
| 17