Specifications - K&S BASIC KSB 22i S Owner's Manual

Model
Max Power, kW
Nominal Power, kW
Engine power, hp
Frequency, Hz
Voltage, V
Current, A (max.)
Output 12V, A
Engine model
Engine cylinder volume cm
Engine type
Maximum ambient temperature
Outlets
Power factor, cosφ
Fuel tank volume, l
Crankcase volume, l
Generator parallel socket
Engine start
Noise level L (7m)/L , dB
PA WA
Performance class
Gross dimensions (L*W*H), mm
Net weight, kg
Protection class
To ensure reliability and increase the engine service life, peak powers may be slightly limited by circuit breakers.
The optimal operating conditions are ambient temperature of 17-25°C, barometric pressure of 0.1 MPa (760 mm
Hg), and relative humidity of 50-60%. Under these environmental conditions, the generator can provide maximum
performance in terms of the declared specifications.
In the event of deviations from these environmental indicators, the generator performance may vary.
Please note that continuous loads exceeding 80% of the generator's rated power are not recommended in order to
extend its service life.
It is recommended to ground the generator before operating it for the first time. Before starting the device, remember
that the total power of the connected power consumers should not exceed the nominal power of the generator.
IMPORTANT!
IMPORTANT!
3
Nominal voltage tolerance – max. 5%
TERMS OF USE OF INVERTER GENERATOR
To avoid electric shock due to poor-quality electrical appliances or
improper use of electricity, the generator must be earthed using
a high-quality insulated conductor.
Make sure that the control panel, the blinds and the underside
of the inverter are well cooled and protected against the ingress
of small solids, dirt, and water. Improper operation of the cooler
can cause damage to the motor, inverter or alternator.

SPECIFICATIONS

KSB 22i S
2.0
1.8
2.7
50
230
7.9
12V/5A
KSB 100i
79.7
gasoline 4 stroke cycle engine
40°С
2х16А
1
4
0.35
+
manual
62/87
G2
540х325х490
21
IP23M
www.ks-power.de/en
3
4
| 3