K&S BASIC KSB 30i S Owner's Manual page 8

IMPORTANT!
ATTENTION - DANGER!
STOPPING THE ENGINE STOPPING THE ENGINE
To stop the engine, proceed as follows:
1. Disconnect all devices connected to the generator, then disable the ECON mode.
2. Allow the generator to run idle for approx. 1-2 minutes.
3. Set the engine switch to the "OFF" position.
4. Turn the fuel valve to the "OFF" position.
5. After the generator stops, allow it to cool down and close the vent
6. Unplug the devices.
Works, specified in "Technical maintenance" section, are to be regularily performed. If the the generator user has
no possibility to perform regular maintenance independently, it is necessary to address the official service center to
registrate an order for such works performance.
You can find a list of service center addresses in your warranty card.
IMPORTANT!
Level check
Motor oil
Replacement
Check /Cleaning
Air filter
Replacement
Cleaning
Spark plug
Replacement
Level check
Fuel tank
Cleaning
Fuel filter
Check (clean out)
- If the generator often operates at high temperature or high load, the oil should be replaced every 25 operating hours.
- If the engine often runs in dusty or other harsh conditions, clean the air filter every 10 operating hours.
- If you missed the maintenance time, perform it as soon as possible to save the generator engine.
The ECON switch must be set back to "OFF" when using electrical
devices requiring a high starting current, such as a compressor or
submersible pump.
DISCONNECT ALL THE DEVICES BEFORE STOPPING THE GENERATOR!
Do not stop the generator with the devices turned on. This may
disable the generator or devices connected to it!
TECHNICAL MAINTENANCE WORKS
MANUAL COMPLIANCE
Technical maintanance, operation and TM K&S Basic generator
storage are to be performed according to this manual recommen-
dations. Manufacturer bears no responsibility for damages and
losses, caused by incompliance to safety requirements and tech-
nical maintanance rules.
TECHNICAL MAINTENANCE WORKS
www.ks-power.de/en
8
| 7