Before Starting - K&S BASIC KSB 30i S Owner's Manual

AC AC INDICATOR INDICATOR
When the generator is running and producing electricity, the AC indicator light is on.
OVERLOAD INDICATOR OVERLOAD INDICATOR
The overload indicator lights up when the connected generator is overloaded, the inverter control unit overheats or
the AC output voltage rises.
If the overload indicator goes on, the engine will continue to operate, but the generator will no longer produce
electricity. In this case, you must perform the following steps:
When the overload indicator light comes on and power generation stops, proceed as follows:
1. Turn off any connected electric devices and stop the engine.
2. Reduce the total wattage of connected appliance into the rated output.
3. Check for blockages in the cooling air inlet and around the control unit. If any blockages are found, remove.
4. After checking, restart the engine.
IMPORTANT!
DC PROTECTOR DC PROTECTOR
The DC protector turns to "OFF" automatically when electric device being connected to the generator is operating
and current above the rated flows. To use this equipment again, turn on DC protector by pressing its button to "ON".
IMPORTANT!
FUEL TANK CAP FUEL TANK CAP
Remove the fuel tank cap by turning it counterclockwise
FUEL TANK CAP AIR VENT KNOB FUEL TANK CAP AIR VENT KNOB
The fuel tank cap is provided with an air vent knob to stop fuel flow. The air
vent knob must be turned to "ON". This will allow fuel to flow to the carburetor
and the engine to run. When the engine is not in use, turn the air vent knob to
"OFF" to stop fuel flow.
EARTHING BOLT EARTHING BOLT
In all cases, except for an IT system with an insulated neutral wire and bonding, the generator earthing bolt must
be connected to the grounding circuit with a flexible copper conductor with a cross-sectional area of at least 6 mm
CHECK THE FUEL LEVEL CHECK THE FUEL LEVEL
1. Unscrew the fuel cap and check the fuel level in the tank.
2. Fill the fuel tank to the fuel filter level.
3. Tighten the fuel cap securely.
IMPORTANT!
The overload indicator may light up within several seconds after
start-up or when connecting electrical devices requiring a high
starting current, such as a compressor or voltage indicator. How-
ever, this is not a malfunction.
Reduce the load of the connected electric device below the
specified rated output of the generator if the DC protector turns
off. If the DC protector turns off again, stop using the device
immediately and contact the point of sale and contact your
nearest K&S Basic TM Service Center.
Immediately wipe off spilled fuel with a clean, dry, soft cloth,
since fuel may deteriorate painted surfaces or plastic parts. Use
only unleaded gasoline. The use of leaded gasoline will cause
severe damage to internal engine parts.
Fuel tank cap
Закрито
Відкрито

BEFORE STARTING

www.ks-power.de/en
Ventilation lever
.
2
6
| 4