Table of Contents
Advertisement
Overview
The ROUTE 56 adapter provides the PC with a single channel high-speed
multi-protocol serial interface suitable for the most popular communication
protocols. This sync/async card provides an ideal solution for high-speed
applications including LAN/WAN connectivity. Utilizing the Z16C32
(IUSC™) on chip DMA controller eliminates bus bandwidth constraints that
are placed on typical PC interface adapters, allowing data rates to reach 10M
bps in burst mode. By utilizing the Z16C32's 32 byte FIFO buffer coupled with
256K of on board memory, higher data rates are achieved without increasing
processor overhead.
What's Included
The ROUTE 56 is shipped with the following items. If any of these items are
missing or damaged, contact the supplier.
•
ROUTE 56 Adapter
•
ROUTE 56 Developers Toolkit Software
•
ROUTE 56 User manual
Factory Default Settings
The ROUTE 56 factory default settings are as follows:
Base Address
300
To install the ROUTE 56 using factory default settings, refer to Installation on
page 5.
For your reference, record installed ROUTE 56 settings below:
Base Address
Sealevel Systems ROUTE 56
Introduction
IRQ
Default Electrical Interface
5
IRQ
Default Electrical Interface
Introduction
RS-530/422
Page 1
Advertisement
Table of Contents
