Trouble Shooting - Luna BBD 150 Original Instructions Manual

7. Locate the pulley cover and position inside the relied edges of
pulley housing.
8. Using a Phillips screwdriver, reinstall and tighten 3-pan head
screws.

TROUBLE SHOOTING

WARNING!
For your own safety, remove the plug from power source outlet before troubleshooting your sander!
TROUBLE
Sander does not operate.
Motor slows when sanding.
Wood burns while sanding.
Sander makes excessive noise.
PROBABLE CAUSE
Not plugged into power outlet.
Power switch defective.
Motor or wiring problem.
Timing belt too tight.
Applying too much pressure on workpiece.
Sanding disc or belt is loaded with debris.
Timing belt too tight.
Bearing need oil.
47
Pulley cover
Phillips screwdriver
REMEDY
Plug into power outlet.
Replace switch.
Have qualified electrician carry out repair.
Decrease tension.
Apply less pressure to workpiece when
sanding.
Clean or replace disc or belt.
Decrease tension.
Oil bearing.