Advertisement
Available languages
Available languages
WARNING! For your own safety, remove the plug from
power source outlet before adjusting your sander.
NOTE: Use a combination square to square the mitre gauge to the
face of the disc combination square must be "true". If it is not squ-
are, loosen the mitre gauge knob and move the mitre gauge,
tighten the knob securely.
Mitre gauge
Combination square
Always position the workpiece to the left of center on the sanding
disc with disc rotating counterblockwise as shown. The table may
be tilted for beveled work.
Center
Workpiece
(Left of Center)
MAINTENCE
WARNING! For your safety, remove the plug from power
source outlet before adjusting, maintaining, of lubricating
your belt and disc sander.
WARNING! To avoid electrocution or fire, any repairs to
electrical system should be done only by qualified service
technicians. Unit must be reassembled exactly to factory specifi-
cations.
If power cord is worn or cut, or damaged in any way, have it repai-
red immediately. Frequently blow out or vacuum out any dust that
may accumulate inside the motor. A coat of automobile-type wax
applied to the worktable will make it easier to feed the work while
finishing. Do not apply wax to the abrasive belt table because the
belt could pick up the wax and deposit it on the pulleys, cause the
belt to slip.
LUBRICATION
The BALL BEARINGS in this machine are packed with grease at
the factory. They require no further lubrication.
CHANGE THE TIMING BELT
1. Using a Phillips screwdriver remove 3-pan head screw located
in the cover.
2. Remove the cover.
Pulley cover
3.Loosen 4-M8 hex head screw with wrench to allow pulley to shift
enough to place belt around them. Place belt around motor pul-
ley and drive pulley as shown if belt is ever broken.
4. Adjust tension of the belt by putting a wrench in adjusting gap.
Push up on wrench to tighten tension between pulleys.
5. Tighten 4-M8 hex head screws careful.
6. Test belt tension by placing fingers on either side of the belt and
squeeze. There should be about a 6 mm give to the belt.
NOTE: Excessive tightness on pulley belt may cause increased
noise and over load motor. Excessive looseness on pulley belt may
cause belt to fail prematurely.
46
Phillips screwdriver
Belt
Advertisement
Chapters
