TechniSat DIGITRADIO 650 Instruction Manual page 79

> If you want to establish a WPS connection instead of entering the password,
proceed as follows after selecting the WiFi network:
How you activate WPS on your router can be taken from its instruction
manual.
> Select [Press button] on the DIGITRADIO 650 after selecting the WiFi
network. Take note of the instructions on the display.
> Start WPS on your router by pressing the relevant button.
> If your router only supports the WPS PIN, select [PIN] on the DIGITRADIO 650
and take note of the PIN shown on the display. You then need to enter the
PIN in the router.
20.3.2 WPS connection
> Select [Internet settings > PBC WiFi set up] if your router has the WPS
function. This establishes a direct connection to the router without having to
enter the WiFi password.
How you activate WPS on your router can be taken from its instruction manual.
> Start WPS on your router by pressing the relevant button. Note the
Instructions on the DIGITRADIO 650 display.
20.3.3 More information about the network connection
To find out more about the current connection select [Show settings].
Select [Manual settings], if you know your network parameters and you
would like to configure them manually. Take note of the instructions on the
display.
The menu item [Net Remote PIN] can be used to configure the PIN for the
control with the TechniSat CONNECT app. The standard PIN is: 1234. The
TechniSat CONNECT app can be loaded free from the usual app stores.
Select [Delete network profile], to delete WiFi connections no longer required.
Select [Reset settings] to clear all current Internet settings.
Select [Allow WiFi connection in standby mode] if the WiFi connection
should be retained in standby mode as well. This setting increases power
consumption but enables app control via the TechniSat CONNECT app
(switching on from Standby mode).
DE
EN
FR
NL
79