TechniSat DIGITRADIO 650 Instruction Manual page 66

13 DAB+ radio
13.1 What is DAB+?
DAB+ is a new digital format through which crystal clear sound with no noise can
be heard. In contrast to conventional analogue radio stations, DAB+ can be used to
broadcast multiple stations on one and the same frequency. This is referred to as
an ensemble or multiplex. An ensemble is comprised of the radio station, as well as
several service components or data services which are broadcast individually by the
radio stations. For further information, please visit e.g.
www.dabplus.ch.
13.2 Switching on DAB+ radio reception
> Press the MODE button as often as required until [DAB Radio] appears on
the display. Or press the DAB+ (13) button on the remote control.
Alternatively:
> Press the MENU button and then select [Main Menu > DAB+].
If DAB+ is being started for the first time, a complete station scan is
performed. The station list is then shown (see Section 13.4).
13.3 Scanning
The automatic scan scans all DAB+ band III channels and thereby finds all stations
being broadcast within the reception area.
After the scan is complete, the first station is played back in alphanumeric
order.
> Press the SCAN button to carry out a full scan. "Scan" appears on the display.
The scan starts and a progress bar appears on the display. The station list is
then shown
> When the scan is complete, press the  or  buttons when the station list is
displayed, and OK to select a station.
Alternatively:
> Press the MENU button and use the  or  buttons [Full Scan]. Confirm by
pressing OK.
If no stations are found, check the antenna and change the installation
location if necessary (Section 6.2).
13.3.1 Manual scan
Proceed as follows if you want to run a station scan manually:
> Select [Menu ] > [Set Manually] and press the OK button.
> Use the  or  buttons to select a station frequency and press the OK
button.
66
www.dabplus.de or