TechniSat DIGITRADIO 650 Instruction Manual page 70

If an FM station with sufficient signal strength is found, the scan stops and
the station is played. If an RDS station is being received, the station name is
displayed and, possibly, the radio text.
To tune in to weaker stations, please use the manual station selection
function.
Under Menu > Scan settings you can set whether the scan only finds strong
stations (Strong stations only). To do so press the MENU button and > Scan
settings > [Yes]. Confirm the selection with OK. With the [NO] setting, the scan
stops automatically at each station. However, these may have interference.
14.5 Setting mono/stereo
> Press the MENU button and use  or  to select > [Audio setting].
> Select [YES] to playback in mono sound only when FM reception is weak, or
[NO] to playback in stereo (only under good reception conditions).
> Confirm by pressing OK.
14.6 Saving FM stations
The favourites memory can store up to 20 stations.
Stored stations are retained even in the event of a power cut.
> Set the station you want.
> Press one of the number keys 0 - 9 on the remote control and hold down
until [saved.] appears on the display.
> Saving more stations: Repeat the process.
Alternatively:
> Hold down the FAV button, use the / buttons to select a favourites
location 1 - 20 and press the OK button.
14.7 Selecting programmed stations
> Briefly press the number key you want 0 - 9. If there is no station saved in
the selected programme slot, [Memory slot empty] appears. An asterisk in
the status bar indicates an active favourite station.
Alternatively:
> Briefly press the FAV button, use the / buttons to select a favourites
location 1 - 20 and press the OK button.
14.8 Deleting a saved memory slot
> Save a new station to the respective programme slot.
70