Table of Contents
Advertisement
Related Links
Film density response data
Accessing the Change settings menu
Changing Image quality settings for a modality - Selecting a lookup
table
1. On the Change settings menu, press the Down key four times, followed by
the Confirm key to select 'Image quality'.
The following screen will appear:
2 <Modality name>
3 <Modality name>
2. Press the Up/Down key, followed by the Confirm key to select the modality
for which you want to change the Image quality settings.
The 'Image quality' screen for the selected modality is displayed:
3. Do one of the following:
• If you want to attribute the default profile, select 'Profile default' and
press the Confirm key.
The printer will be loaded with these settings and return to the 'Image
quality' main menu (see step 1).
• If you want to add a custom profile, select 'Select other' and press the
Confirm key. Proceed with step 4.
• If the parameter for the selected modality has been set via a remote
computer, you will not be able to change the image quality information
for this modality via the local keypad. In this case the following screen
will appear:
<Modalityname>
DRY 1.4, DRY 2.4 | Advanced Operation (key-operator mode) | 39
Note: All shown densities will vary slightly according to the
densitometer selection.
on page 132
on page 23
Note: In case the image quality parameters need to be
changed for this modality, please use the DICOM
Configuration tool in the Key-operator mode via a remote
connection. Alternatively, you can also remove this modality
and add a new modality with the same name. For this new
3630B EN 20210520 0952
Advertisement
Table of Contents
