SYSMEX CyStain VitalCount Manual page 10

4 Operation
7. Press [Start] again to run QC Robby.
8. Follow the instructions and Click [Continue] to start FCS Express.
NOTICE
Adjusting Device Settings during a Quality Check
Signals should be visible in all dotplots. The predefined QC regions
indicate the position where the signals of the beads are expected.

If the beads signals are not within the predefined region, adjust the gain
values , see chapter 4.2.1 Setting up the Quality Check.
Results
The QC procedure results can be analysed in FCS Express™. Continue by analysing the
Quality Check with FCS Express™.
10
Figure 12:CyView Start Robby
CyStain™ VitalCount QC Procedure | QC Manual | June 2021