Removal; Assembly - JLG RT2669 Service And Maintenance Manual

SECTION 3 - CHASSIS, PLATFORM, & SCISSOR ARMS
1. Axle
2. Pivot Pin

Removal

SUPPORT THE FRAME AND AXLE BEFORE ATTEMPTING ANY REMOVAL
AND/OR ASSEMBLY PROCEDURES.
1. Disable machine operation. Remove wheel and drive
assemblies.
2. Remove the bolt and pin keeper (5).
3. Push the axle pivot pin (2) out and remove the thrust
washer (4).
4. Axle (1) can now be moved away from the frame.
3-56
7
6
8
7
6
3. Pivot Pin Bushing
4. Thrust Washer
Figure 3-38. Axle Installation (Rear Axle)- For Dual Oscillating
3
2
5
1
5. Pin Keeper and Bolt
6. Wear Pad Shim

Assembly

1. When installing the axle assembly, follow Removal
Steps in reverse.
2. If removed, shim the wear pad to achieve a maxi-
mum gap of 0.06 in. (1.5 mm) between the pad and
the axle machined surface.
3. For Dual Oscillating Rear Axle If removed, shim the
wear pad to achieve a maximum gap of 0.12 in. (3
mm) between the pad and the axle machined sur-
face.
NOTE: Apply Medium Strength Threadlocking Compound
to bolts (8) attaching wear pad (6) to the frame.
torque to 35 ft. lbs. (47 Nm).
Inspect bushing, replace if damaged.
3
4
MAF42460A
7. Wear Pad
8. Hex Head Screws
31215923