FNM HPE Series Owner's Manual page 87

Never start the engine without the air filter in place! It can produce serious damage to
the engine.
3.3.10 Engine and transmission oil change
Ordinary maintenance: made by the boat user and the workshop staff.
To change engine and transmission oil, comply with the procedures listed below:
3.3.10.1 Engine oil change
1. Turn off the engine.
2. If you have used recently used it, let the engine cool down for at least 20 minutes, to help oil
flowing in the sump.
3. Prepare a container of proper capacity to collect exhaust oil
4. Connect a hose to the drain valve on the sump. The exhaust valve position changes depending
on the model of your engine, and is indicated in Chapter 1.6 - Main components of FNM®
engine, HPE Series – on page 15.
5. Connect a pump to the hose end, then open the drain valve.
6. Open the oil refill cap to facilitate the suction. The cap is located on top of the engine and is
described in section 1.6 - Main components of FNM® engine, HPE Series – on page 15.
7. Operate on the pump to transfer the oil.
®
FNM HPE Series 83