FNM HPE Series Owner's Manual page 58

To acquire the command with stopped boat.
1. Position all the command stations in neutral;
2. Keep the Command button pressed for at least 1 second;
3. The Command LED will light and the Warm/Sync LED will begin blinking;
4. Now you are in the warm-up mode, i.e. the gearboxes are disabled. It is only possible to
accelerate to carry out the engines preheating operation;
5. To definitely take the command of the station you must reposition the levers in neutral position
and hold the Warm/Sync button for 2 seconds;
Now the command lever is enabled and ready for use.
To acquire the navigation command:
1. Synchronize the 2 levers of the station of which you want to acquire the command with respect
to the station which has the command;
2. the Engine led starts blinking when the lever of the calling station is in phase with the lever of
the station that has the command (with an accuracy of 10 degrees). ;
3. when both levers are synchronized (and therefore the corresponding Engine leds are blinking)
it is possible to acquire the command by pressing the Command button for 2 seconds.
54
®
FNM HPE Series