FNM HPE Series Owner's Manual page 39

In Selection mode pressing the down arrow allows to switch from screen 1 to screen 2, and so on.
Pressing the up arrow allows you to go back. Screen 8 is displayed only if there are errors or warnings
to report.
The information you can see are the following:
(1) Volts: is the operating voltage of the battery in volts.
(2) Trim: is the position proportional to the trim inclination angle.
The Trim location information is only available in applications that require the adjustment of the
trim, such as the stern drive.
(3) Oil Press: is the engine oil pressure in bar or PSI.
(4) Engine Hour: is the total number of running hours of your marine engine.
(5) Fuel Level and Fuel Left: it is an indication of the fuel level in the tank.
(6) Water Press: is the engine coolant pressure.
(7) Fuel Used: is the amount of fuel used since last reset of the instrument.
Information relating to the fuel (Fuel Level, Fuel Left, Fuel Used) are available only with a
special float for the level measurement. Get information from your installer if it is installed on
your boat.
(8) Trans Gear: shows the current gear engaged in the transmission.
(9) Trans Temp: Indicates the current oil temperature in the transmission.
®
FNM HPE Series 35