Transmitter Setup; Model Type Setup; Transmitter Phase Setup; Flight Mode - RadioLink A560 Instruction Manual

RadioLink Electronic Ltd
www.radiolink.com

3.2 Transmitter Setup

3.2.1 Model Type Setup

For A560 PNP version, model type needs to be set as fixed wing in the transmitter. Take AT9S
Pro as example( same as AT10II/AT9S/AT10/AT9).
Steps: Power on the transmitter - Long press Mode to enter BASIC MENU - Turn the Dial to
MODEL TYPE - Press Push to enter the menu and turn Dial to select ACROBASIC - Long
press Push for 1 second and a notice "ARE YOU SURE"pops out - Press Push again and a
notice"Please wait..." pops out and there will be DEE sound heard, meaning setting complete.

3.2.2 Transmitter Phase Setup

Please set the direction of CH3 to Reverse, and other channels CH1/CH2/CH4 to Normal.
Take AT9S Pro as example( same as AT10II/AT9S/AT10/AT9).
Steps: Long press Mode to enter BASIC MENU - rotate Dial to REVERSE - Press Push to
enter the menu - rotate Dial to 3:THRO - change NOR to REV - Long press Push for 1
second to confirm.

3.3 Flight Mode

3.3.1 Flight Mode Setting

With the three-axis gyroscope and three-axis acceleration sensor and the full attitude
algorithm, control algorithm and digital filter, the integrated flight controller Byme-A specially for
3D fixed wing, is different from traditional manual mode. Working with gyro to assist
stabilization, Byme-A makes the flight much easier.
There are five flight modes: Vertical Mode, Stabilize Mode, Gyro Mode, Acrobat Mode, Manual
Mode. Flight modes are switched by CH5(3-way switch) and CH7(2-way switch) by default.
24