Esc; Servo; Propeller - RadioLink A560 Instruction Manual

1.3.5 ESC

The function of ESC is to change the direct current to alternating one to power supply motor
and change its rotation speed basing on the throttle command. Another function of ESC is to
lower the model voltage to 5V for receiver as the battery applied for A560 is 7.4V 2S LiPo
Battery. Therefore, there are three wires of ESC respectively for battery, motor and receiver.
ESC applied in A560 is FLYCOLOR 15A brushless ESC.
Usage of ESC:
Make sure there's a tone from ESC when power on the aircraft.

1.3.6 Servo

A560 uses a EMAX 8G servo as aileron servo and 2 pieces of 4.3G servo for elevator servo
and rudder servo respectively.

1.3.7 Propeller

A560 adopts GEMFAN 8030 propeller, which is installed by factory default. If new propeller
needs to be changed, fix the propeller and motor with a rubber band.
Propeller need to be identified correctly. If forward and reverse mistaken, the aircraft couldn't
take off even maximize the throttle. The rotation direction of motor and propeller should be the
same. That is, if the motor rotates clockwise, so is the propeller.
A560 is standard packed with 2 GEMFAN 8038 propellers. If you need to replace the propeller,
please put the below No. 2 propeller ring into the propeller, as shown in the following pictures.
Usage of propeller:
Make sure to check the propeller is in good condition before flight. If aged, damaged or

deformed, please change to good one then flight.
Make sure to disconnect the power supply before touching the propeller.

As propeller is thin, use tools to (un)install if necessary and be careful to avoid accidental

RadioLink Electronic Ltd
9
www.radiolink.com