Flight Controller Phase; Flight Controller Phase Test - RadioLink A560 Instruction Manual

RadioLink Electronic Ltd
www.radiolink.com
Note
1. Make sure attitude calibration is done before servo phase calibration. Because flight
controller will auto identify NOR/REV and modify gyro direction when doing attitude calibration.
2.
Neither the always-on nor off green LED means reversed phase. Only toggle the joysticks
can check if the corresponding servo phases are reversed.

5.2 Flight Controller Phase

5.2.1 Flight Controller Phase Test

After checking the right transmitter phase, it is necessary to check the flight controller phase of
A560. (The transmitter phase must be checked first, and then flight controller phase.)
Make sure to switch to STABILIZE MODE (eg. T8S CH7-DOWN, CH5-DOWN) to check flight
controller phases are correct before each flight. Below Mode 2 is explained as example.
（1）Aileron phase on flight controller
Toggle the aileron joystick to left, left aileron is lifted and right one is pressed; toggle the
joystick to right, left aileron is pressed and right one is lifted, meaning the aileron phase on
flight controller is correct.
（2）Elevator phase on flight controller
Toggle the elevator joystick downward, elevator servo(horizontal tail) is lifted; toggle the
joystick upward, elevator servo(horizontal tail) is pressed, meaning the elevator phase on flight
controller is correct.
20