Chapter 5 Servo Phase; Transmitter Phase; Transmitter Phase Setup; Transmitter Phase Test - RadioLink A560 Instruction Manual

RadioLink Electronic Ltd
www.radiolink.com

Chapter 5 Servo Phase

5.1 Transmitter Phase

5.1.1 Transmitter Phase Setup

A560 RTF version has already set up transmitter phase, but please check it again before
taking off. Please check the transmitter phase in T8S Parameter Setup APP. Enter the basic
menu. Set CH1/CH2/CH4 to NORM, and CH3 to REV, as shown below:
Click https://www.radiolink.com/t8s_apps to download T8S Parameter Setup APP and click
https://www.radiolink.com/t8s_manual to download the detailed manual of T8S in RadioLink
official website.
Note
1. After the phase setting in T8S transmitter, please refer to 6.2 Attitude Calibration to
calibrate the attitude once, and then check the transmitter phase.
2. After the phase setting in T8S transmitter, please keep the setting and do not make any
modifications. If the control surface of the aircraft moves incorrectly when pushing the stick,
please change the direction of the corresponding channel on the flight controller.

5.1.2 Transmitter Phase Test

After completing the phase setting in T8S transmitter and an attitude calibration, please check
whether the transmitter phase is correct. Make sure to switch to MANUAL MODE(eg. T8S
CH7-DOWN, CH5-UP) to check phases are correct before each flight. Below Mode 2 is
explained as example.
（1）Aileron phase
Toggle the aileron joystick to left, left aileron is lifted and right one is pressed; toggle the
joystick to right, left aileron is pressed and right one is lifted, meaning the aileron phase is
correct.
17