Chapter 5 Servo Phase; Chapter 6 Flight Controller Calibration; Power-On Calibration; Attitude Calibration - RadioLink A560 Instruction Manual

RadioLink Electronic Ltd
www.radiolink.com

Chapter 5 Servo Phase

Please refer to A560 RTF Chapter 5 Servo Phase.

Chapter 6 Flight Controller Calibration

6.1 Power-on Calibration

Please refer to A560 RTF Chapter 6 Power-on Calibration.

6.2 Attitude Calibration

Flight controller Byme-A needs to calibrate the attitudes/level to ensure the balance status.
(1) It is advised to place the landing gear of A560 on the standard package, which is equivalent
to raising the nose at an angle of about 20 degrees, and then operate the transmitter to
calibrate the attitude. Lifting up the head with a certain angle is helpful for flight balance.
(2) Push the left stick (left and down) and the right stick (right and down) as below and hold
more than 3 seconds. The green led flashes once mean the calibration completed. It is also
normal for the control surface to swing or the motor to rotate once at this time.
Note: When using a non-RadioLink transmitter, if the attitude calibration is unsuccessful when
pushing the left stick (left and down) and the right stick (right and down), please change the
direction of the channel in the transmitter. Make sure when pushing the joystick as above, the
value range of channel 1 to channel 4 is:
26