Flight Controller Phase - RadioLink A560 Instruction Manual

detailed manual. Manuals of other RadioLink transmitter are also available on
www.radiolink.com .

2.3.3.2 Flight Controller Phase

After checking transmitter phase , flight controller phase on A560 also needs to be checked as.
Note Transmitter phase should be checked before flight controller one. When checking flight
controller phase, flight mode should be set as STABILIZE MODE(eg. T8FB SWA-UP,
SWB-UP)..
（1）Aileron Phase on FC
Hold A560 with the aircraft body level. Lean/roll it to left, if left aileron is pressed and right one
is lifted; then lean/roll it to right, if left aileron is lifted and right one is pressed, meaning the
aileron phase on FC is correct.
（2）Elevator Phase on FC
Hold A560 with the aircraft body level. Lift up the aircraft head, the elevator servo(horizontal
tail) will be lifted. Pitch down the aircraft head, the elevator servo(horizontal tail) will be
pressed. Then the elevator phase on FC is correct.
（3）Rudder Phase on FC
Hold A560 with the aircraft body level. Turn it left, the rudder servo(vertical tail) will turn to left.
Turn it right, the rudder servo(vertical tail) will turn to right. Then the rudder phase on FC is
correct.
If flight controller phase is reversed, press the button at the top of flight controller Byme-A to
change servo phase. All flight controller phases can be reset except throttle phase. If throttle
resetting is necessary, please enter the transmitter parameter setup menu-servo phase.
No. Channel
1 AIL
2 ELEV
3 THRO
4 RUDDO
Note Make sure attitude calibration is done before servo phase calibration. Because flight
controller will auto identify NOR/REV and modify gyro direction when doing attitude calibration.
If phase is reversed,
Short press the button once
Short press the button twice
N/A
Short press the button four times
Green led to CH1 on/off
Green led to CH2 on/off
Green led always on
Green led to CH4 on/off
Button to
change
FC servo
phase
9
RadioLink Electronic Ltd
www.radiolink.com
Indicator LED