Feider Machines FPG710-SH Instruction Manual page 17

4.Disposal and recycling
The appliance is supplied in packaging to prevent its being damaged in transit.This
packaging is raw material and can therefore be reused or can be returned to the raw
material system.
The appliance and its accessories are made of various types of material,such as metal
and plastic.Defective components must be disposed of as special waste.Ask your dealer
or your local council.
5. Use and maintenance of the tool
a) Do not force the tool. Use the right tool for your application. The adapted
tool will do all the work and more safely at the speed for which it was built
b) Do not use the Tool if the switch does not switch from on to off.
Any tool that cannot be controlled by the operator is dangerous and needs to
be repaired.
c) Disconnect the plug from the power source and / or the battery pack from
the front tool any adjustment, change of accessories or before storing the tool.
These preventive safety measures reduce the risk of accidental starting of the
tool.
d) Keep tools at a standstill out of the reach of children and do not allow
unauthorized persons not knowing the tool or these instructions to operate it.
Tools are dangerous in the hands of novice users.
e) Observe the maintenance of the tool. Check that there is no misalignment or
blockage of the moving parts, broken parts or any other condition that may
affect the operation of the tool. If damaged, have the tool repaired before using
it. Many accidents are due to poorly maintained tools.
f) Keep cutting tools affinities and clean. Properly maintained cutting tools with
sharp cut pieces are less likely to jam and are easier to control.
g) Use the tool, accessories and blades etc., in accordance with these
instructions, taking into account working conditions and the work to be done.
The use of the tool for different operations planned attacks could give rise to
dangerous situations.
6. Maintenance and care
a) Have it checked by a qualified repairer using only identical spare parts. This
will ensure that the safety of the tool is maintained.
17