Feider Machines FPG710-SH Instruction Manual page 11

3. OPERATING INSTRUCTIONS
3.1 Before starting the appliance
Before you connect the appliance to the mains supply make sure that the data on the
rating plate are identical to the mains data.
Always pull the power plug before making adjustments to the appliance.
3.1.1 Changing the abrasive paper
The sanding/polishing disk comes with a Velcro fastening system for sanding/polishing
paper to be attached without a clamping device.
Before you attach a new piece of sanding/polishing paper,knock out any dirt from the
Velcro fastener and clean with a brush or, if necessary, with compressed air.
Place the sanding/polishing paper on the sanding/polishing disk. Fix the sanding/polishing
paper in place by pressing it firmly with your hand.
3.1.2 Fitting the dust extraction system
The dust extraction system prevents the accumulation of dirt and high dust loads in the air,
and it makes it easier to dispose of the dust.
Connect the hose (1) on both ends with the connectors (2+3), at which point, the

hose must
click-in to the connectors (see "Connection Piece").
The thinner connection piece (2) should now be connected to the handle

To dismantle the hose, carefully press into the notches with the flat side of the

enclosed screwdriver. By doing this,the interlocking lugs are released from the
notches and the hose can be taken back out of the mount.
Connect your appliance to an extraction unit or vacuum cleaner. This will provide

excellent extraction of chips and dust from the workpiece.
Advantages:The advantages are that you will protect both the appliance and your own
health. Your work area will also be clean and safe.
Suction Hose Connection
(4).
Connection Piece
11