Table of Contents
Advertisement
September 2004
Entering Global System
Data [GLOBL-SYSTM
Menu]
Selecting the
GLOBL-SYSTM Units
Selecting the System Units
2-12
Refer to Figure A-2 on page A-2, and complete the steps below to
enter system information in the
1. Press [ESC] , [ENTER] , [ESC] in sequence to enter the user program.
2. Press [ ] until PROG appears and press [ENTER] .
3. Press [ ] until GLOBL appears and press [ENTER] .
4. Press [ ] until SYSTM appears and press [ENTER] .
5. Enter a short message (up to 16 characters) by using the arrow
]
keys. Press [
and [ ] to move the cursor to the desired location
[ ] and [ ]
and press
[ENTER] .
1. Press [ ] to select the system units and press [ENTER] .
2. Do one of the following:
•
1-Channel Meters - go to Setting Up the External Totalizer
Reset Switch on the next page.
•
2-Channel Meters - continue with the next step.
3. Press [ ] to select the volumetric units for the flow rate display
and press [ENTER] .
4. Press [ ] to select the number of digits to the right of the decimal
point in the volumetric flow rate display and press [ENTER] .
5. Press [ ] to select the desired units for the totalized flow rate
display and press [ENTER] .
6. Press [ ] to select the desired number of digits to the right of the
decimal point in the totalized flow rate display and press [ENTER] .
menu.
GLOBL
to select the desired character. Then press
Programming Site Data
Advertisement
Table of Contents
