Table of Contents
Advertisement
Special Transducers
Special Clamp-On
Transducers
Programming Site Data
1. For a special transducer, press [ ] to move the cursor to STD and
[ ]
until SPEC appears and press [ENTER] .
press
2. Assign a number between 90 and 99 to the special transducer.
Enter the number by using the arrow keys. Press [
move the cursor to the desired location and press
increase or decrease the number. Then press [ENTER] .
]
3. Press [
and [ ] to select the wedge type (supplied by GE) and
press [ENTER] .
]
4. Press [
and [ ] to select the transducer frequency (supplied by
GE) and press [ENTER] .
5. Enter the special transducer time delay value (supplied by GE) by
using the arrow keys. Press [
desired location and press
the number and press [ENTER] .
The following two prompts appear only if special clamp-on
transducers are being used. If special wetted transducers are being
used, proceed to Pipe Outside Diameter on page 2-7.
1. Enter the wedge angle (supplied by GE) of the transducer by using
the arrow keys. Press [
desired location and press
the number. Then press [ENTER] .
2. Enter the wedge sound speed (supplied by GE) of the transducer
by using the arrow keys. Press [
the desired location and press
decrease the number. Then press [ENTER] and proceed to Pipe
Material on the next page.
[ ] and [ ]
]
and [ ] to move the cursor to
[ ] and [ ]
to increase or decrease
]
and [ ] to move the cursor to the
[ ] and [ ]
to increase or decrease
]
and [ ] to move the cursor to
[ ]
[ ]
and
to increase or
September 2004
]
and [ ] to
to
2-5
Advertisement
Table of Contents
