Configuring The Communications Port [Globl-Comm]; Taking Measurements - GE AquaTrans AT868 Abridged Manual

Panametrics liquid flow ultrasonic transmitter

Hide thumbs Also See for AquaTrans AT868:

Table of Contents

September 2004

Configuring the

Communications Port

[GLOBL-COMM]

2-18

The AT868 is equipped with a built-in serial communications port, as

described in Chapter 1, Installation. Refer to Figure A-2 on page A-2

and use the

GLOBL-COMM

completing the following steps:

1. Press [ESC] , [ENTER] , [ESC] in sequence to enter the user program.

2. Press [ ] until PROG appears and press [ENTER] .

3. Press [ ] until GLOBL appears and press [ENTER] .

4. Press [ ] until COMM appears and press [ENTER] .

5. Enter a meter address (between 1 and 254) by using the arrow

keys. The default number is 1. Press [

cursor to the desired location and press

or decrease the number. Then press [ENTER] .

Note: A meter address is only necessary for communication with the

GE Panaview software. See the Panaview User's Manual for

more information.

6. Press [ ] to select a baud rate and press [ENTER] .

The AT868 has now been totally programmed for taking accurate

flow rate measurements. Proceed to Chapter 3, Displaying Data, for

instructions on configuring the display.

menu to set up the communications port by

]

and [ ] to move the

[ ]

and

Programming Site Data

[ ]

to increase

Table of Contents