Table of Contents
Advertisement
September 2004
Setting Up the Display
Accessing the Display
Submenu
Configuring the Display
3-2
Follow the instructions in this section to display the desired data on
the display screen (see Figure A-2 on page A-2 in Appendix A, Menu
Maps
1. Press [ESC] , [ENTER] , [ESC] in sequence to enter the user program.
2. Press [ ] until PROG appears and press [ENTER] .
3. Press [ ] until GLOBL appears and press [ENTER] .
4. Press [ ] until I/O appears and press [ENTER] .
5. Press [ ] until LCD appears and press [ENTER] .
1. At # of LCD PARAMS , press [ ] to select the desired number of
parameters to be sequentially displayed and press [ENTER] .
2. For a 1-channel AT868, proceed to Step 4. For a 2-channel AT868,
proceed to Step 3.
3. Press [ ] to select the desired channel option and press [ENTER] .
4. At Measurement Name , press [ ] to select the desired parameter
and press [ENTER] .
5. Repeat the two previous steps until all of the specified # of LCD
PARAMS have been set up.
Note: The measurement units that appear in these prompts are those
selected in the GLOBL-SYSTM menu as described in Chapter
2, Programming Site Data.
After leaving the User Program, the AT868 will reset and will begin
to display the parameters specified in this section. If more than one
parameter was set up, each of the parameters will be displayed in
sequence, with a pause of several seconds between display changes.
Displaying Data
Advertisement
Table of Contents
