ABB ACS2000 User Manual page 98

Chapter 4 - Transportation, storage and disposal
4.1.2.3 Using a forklift
4-4 (8)
NOTICE
Maximum angle between lifting slings must be less than 5° from vertical.
• Lift the cabinet slowly and steadily to the required clearance height,
keeping the cabinet in an upright position.
• Check the horizontal position of the cabinet. Reposition the slings if
necessary.
• Care must be taken to ensure that the lifting straps do not damage the
drive cabinet or fan boxes.
Note: The lifting brackets can be removed after the cabinet has been
installed at its final location.
Observe the following points when using a forklift:
• Transport the cabinet by fully inserting the forks into the cabinet's
forklift pockets either from the right or left side of the cabinet (see
Figure 4-3).
• Do not attempt to lift entire cabinet, a forklift is only recommended
when the opposite side is left to slide on the floor.
Front of drive
Legend
1 Forklift pocket
2 Lifting brackets
Figure 4-3 Transporting the cabinet by forklift (Frame 2 pictured)
2UEA001270 Rev. F
Side of drive
2 1 2
ACS2000 User manual