Chapter 10 - Troubleshooting and maintenance
5
Remove the plexiglas air plenum
by removing the six screws.
•
Screw type: M6 socket-head
screw
•
Required tool: 10 mm socket
When working on the AFE, first pull
out the air pressure tube at the
bottom of the panel.
6
Unplug fiber optic cables and
control wiring connector from the
front of the phase module.
Carefully position cables to prevent
damaging them when changing the
phase module.
7
Remove the screws on the left/right
side of the phase module.
•
Screw type: M10 socket-head
screw
•
Required tool: 10 mm socket
8
Frame 1 - Insert the module tray
into the cabinet along the lower
sides of the phase module.
•
Slide the phase module tray
tool in, until it makes contact
with the metal flange on both
sides of the NP frame.
10-28 (32)
2UEA001270 Rev. F
Remove 6 screws
Phase module
screws
ACS2000 User manual