5.12.3
Program change
The active program can be changed and saved.
The rotary knob is used to select the parameter to be changed. Pressing the rotary knob
activates the selected parameter. Its type or value can then be changed by turning the rotary
knob. Pressing the knob again confirms and applies the parameter change. The marking
modified is shown next to the program name on the right side of the display when a laser
parameter of the current program is changed. Modified disappears when the program is
saved under the same or a new name.
The adjustable parameters are described in the following sections.
5.12.4
Laser output
5.12.5
Operating modes
46
Laser Surgical Unit diomax
Laser power (Laser output)
•
Use the rotary knob to select and adjust
(0.1 - 15 W)
•
Output from 0.1 to 15 W can be selected in
continuous mode, pulsed mode, cycle mode
and single mode
Output from 1 to 15 W can be selected in
•
the continuous rate and pulse rate operating
modes.
Operating mode
•
Use the rotary knob to select the mode and
activate it by pressing the knob. Select the
desired operating mode from the list.
Instructions for Use
®
1550
Revision 2