Installation (Installation To The Basic Unit) - Toshiba nv Series Instruction Manual

Chapter 2 Installation and Wiring
2.1

Installation (Installation to the Basic Unit)

8
6F8C1361
Before installing or removing the module, make
WARNING
sure that the basic unit to which the FN812
module is installed is turned off.
Otherwise, it may cause an electric shock.
Do not touch the interior of the product except
WARNING
the switches.
It may cause an electric shock.
Install it under an environment that satisfies the
CAUTION
product specifications.
When installing it under an environment that does not
satisfy the product operating temperature range, apply
forced cooling with cooling equipment.
Operating temperature range: 0 to 55°C
Before installation or wiring, remove the static
CAUTION
electricity from your body.
The static electricity accumulated in the human body
may cause failure of the product.
When installing the product to the basic unit, do
CAUTION
not bend the pins of the station bus connector.
If it is difficult to insert the module to the basic
CAUTION
unit, remove it once and try again rather than
forcing it.
When installing two or more Ethernet modules to
CAUTION
the same basic unit, make sure that the system
and segment of the transmission path are correct.
Use a Phillips screwdriver.
CAUTION
To prevent damage to the screws, use a screwdriver
that is suitable for the screws.
Mandatory
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited