Toshiba nv Series Instruction Manual page 49

Chapter 4 Operation
The switches of the product have been adjusted for the system at the site
adjustment. For normal operation, do not change any switch other than the
ones the customer is required to operate.
Checking before operation
Before turning on the power and operating the product, check again that the
following are as described in this operation manual:
• Checking the switch settings
Startup operation
When the power supply module is turned on, the module starts running
automatically.
When the FN812 module is up and running, check that it is operating correctly
by referring to "Table 1-1 Display on the state display LED and normal display"
on page 5.
If the module doesn't start up or if the operation is erroneous, stop using the
product immediately and contact one of Toshiba's service representatives.
Shutdown operation
To shut down, turn off the power of the power supply module.
36
6F8C1361
Avoid incorrect setting.
CAUTION
The product does not operate normally if the switches
are set incorrectly. Read this operation manual
thoroughly to avoid incorrect setting.
Stop using immediately when an error occurs.
CAUTION
When an error occurs such as unable to turn on the
power, stop using and contact one of Toshiba's service
representatives.
• Switch setting
• Installation
• Wiring
Note
Use the engineering tool to check the switch settings (station address setting switch and
operation mode setting switch).
Prohibited
Mandatory