Cisco NCS 540 Installation Manual page 41

Small density passive cooled routers

Hide thumbs Also See for NCS 540:

Table of Contents

Install the Cisco N540-6Z14S-SYS-D Routers

Figure 16: Install an SFP Module into an SFP Module Slot

5. Insert the cable connector into the SFP module.

Remove SFP Modules

To remove an SFP module from a module receptacle, follow these steps:

1. Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.

2. Disconnect the cable from the SFP module, and insert a dust plug into the cable end.

3. Unlock and remove the SFP module, as shown in the following figure.

If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp latch

is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver or other

long, narrow instrument to open the bale-clasp latch.

Cisco Network Convergence System 540 Passive Cooled Small Density Routers Hardware Installation Guide

Caut i o n

Do not remove the dust plugs from the fiber-optic SFP module port or the rubber caps from the

fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP

module ports and cables from contamination and ambient light. Store the dust plugs for later use.

Tip

For reattachment, note which cable connector plug is transmit (TX) and which is receive (RX).

Remove SFP Modules

Table of Contents