Tesla HS300WX User Manual page 5

ASSEMBLING THE VACUUM CLEANER WITH
ACCESSORIES
Install the floor brush head:
The floor brush head is suitable for all floors.
Floor brush head connected directly to the vacuum
cleaner body unit until you hear a audible clicking
noise.
Floor brush head connected with the aluminum tube
until you hear a audible clicking noise.
Disassemble the floor brush head:
Press the tube release button, then remove the
aluminum tube and floor brush head.
Install the 2in1 crevice nozzle:
The crevice nozzle is suitable for narrow gaps
cleaning and for using on upholstered surface
cleaning.
Insert the 2 in 1 crevice nozzle into the connecting
joint, then insert the connecting joint to the vacuum
cleaner body unit.
The brush on the crevice nozzle can be pulled
forwards or backwards as need.
Install the blowing device.
The blowing device is used for the blowing function.
The blower function is recommended for use to
gather scattered dry waste such as dust, leaves and
confetti or any new ideas from you.
Insert the blowing device into the vacuum cleaner
body.
You can adjust the blowing direction and blowing
force by adjusting the blowing tube direction and
vacuum cleaner power speed.
Install the extension aluminum tube
Floor brush head connected with aluminum tube for
use to clean the hard floor or carpet.
2in1 crevice nozzle Connected with aluminum tube
for use to clean the high places such as ceiling,
curtain, and etc.
5