Table of Contents
Advertisement
Image 3–15
6.
Mount the rear and front top fixation brackets.
1. Start with placing the fixation bracket on its place (1).
2. Turn in both bolts (2) (B362161) . Place a washer (G115690) between the bolts and the fixation plate.
3. Turn in the four bolts (3) (V3624376). Place a washer (V3673791) between each bolt and the fixation
plate.
1
2
Image 3–16
3.4 Projector configurations
The different configurations
The projector can be installed on a table or be hung from a truss beam, and this in a front projection or rear
projection configuration. This can happen as long as the projector is not hung upside down (the top cover can
not face downward). Depending on the physical configuration of the projector and the used lens (e. g. UST
lenses), the projected image may have to be flipped horizontally and/or vertically.
The projected image can be adapted via the menu: Configuration > Projector > Image orientation.
Front projection
The projector is installed, either on a table or hanging from a truss beam, at the same side of the audience.
3
A
Installation preparations
3
1
2
B
R5914481 /02 XDX
33
Advertisement
Table of Contents
