Table of Contents
Advertisement
Installation procedures
Image 4–27
3.
Place the projector under the truss installation with the clamps facing upwards. Lower the truss until the
support bars of the truss are close enough to connect the rigging clamps.
Warning:
Image 4–28 Example of mounting to truss
4.
Lock all four rigging clamps.
5.
Secure the reinforcement frame and truss installation using safety cables.
Warning:
that faces the truss beam (the same bars as used for the clamps).
Warning:
Safety cables must be dimensioned for the applicable load and no drop distance is allowed or
must be limited as much as possible.
6.
Lift up the truss with the attached projector to the desired height.
56
R5914481 /02 XDX
Always secure the rigging points after adjustment.
Make sure the safety cables are mounted on the longest bars on the side of the frame
Make sure all safety cables are applied according to local regulations and standards.
Advertisement
Table of Contents
