Barco XDX Series Installation Manual page 68

Starting the projector for the first time
Note: Keep in mind to unzip the package. Only *.fw files can be selected for software updates.
2. Make sure the projector is powered on and is in READY mode.
3. Browse to the Web Communicator application and log in as administrator.
4. Click on tab Maintenance and select Software update.
5. In the Software Update menu, click Browse for a package to install.
An Open browse window is prompted.
Image 6–9
6. Select the file downloaded from the Barco website.
The selected file will be mentioned under Manual update.
Image 6–10 Example of an update package
7. Click Install and confirm.
The software update will start.
How to update the software via USB device
1. Download the latest firmware from the Barco website. Click on myBarco and login to get access to
secured information. Registration is necessary.
If you are not yet registered, click on New to myBarco and follow the instructions. With the created login
and password, it is possible to login where you can download the software.
Note: Keep in mind to unzip the package. Only *.fw files can be selected for software updates.
2. Make sure the projector is powered on and is in READY mode.
3. Browse to the Web Communicator application and log in as administrator.
4. Click on tab Maintenance and select Software update.
5. Plug a USB device with the downloaded file into the USB port of the Cinema Controller.
Note: The USB device should be formatted in FAT-32. It may only contain the firmware file in the
root level of the device.
The USB device will be detected and a window will prompt in the Web Communicator.
68 R5914481 /02 XDX