Adjust Ing T He Pr Int Head Pr Essur E Dials - Avery Dennison ADTP2 Operator's Handbook Manual

5. Press  or  to increase or decrease the contrast. Increasing the contrast setting
darkens the print; decreasing the contrast setting lightens the print.
Note : Press the left function button to change the amount (adjusts to change by 1, 10,
or 100).
6. When you see the contrast setting you need on the display, press SET to save.
7. Press BACK until you see " Ready," then press SELECT.

Adjust ing t he Pr int head Pr essur e Dials

T wo dials are located on either edge of the printhead assembly.
screwdriver to adjust the dials based on the wi dth of your suppl y. T he " out of the box"
setting (default) is least pressure, which provides optimal printing in most cases.
If you see smudging, ribbon wrinkling, or poor print quality, adjust the printhead pressure
dials.
Note : Both dials must be set to the same position.
Knob i s se t to l e a st pre ssure a dj ustm e nt (knobs a re up).
Most P re ssure
Each dial has four settings:
Least pressure
♦
Light pressure
♦
Medium pressure
♦
Most pressure
♦
6-2 Operator's Handbook
Le a st P re ssure
Use a coin or flathead