For Ethe rne t Com m unications:
If you are using Ethernet communi ca tio ns, you can
monitor the status using the LEDs as shown:
Top LED:
Blinking
green
Bottom LED:
Orange
U s i n g t h e C o n t r o l P a n e l
T he control panel has an LCD display and five buttons. T he top three buttons are
function buttons, which vary depending on the task shown above the button. T he two
bottom buttons are navigation buttons; use these to scroll through menus.
T he LCD
uses a red background when immedia te attention (jam or error)
♦
is required. For more information see Chapter 6
T roubleshooting
."
uses a green background when the printer is active
♦
(printing or receiving data).
uses a white background when viewing menu prompts,
♦
printer settings, button functions, etc.
Select ing a Funct ion
Your System Administ rat or can access the MENU to configure the
printer.
Press MENU.
♦
Press or to see the menu options.
♦
Press SELECT when you see the menu option you need.
♦
Exit ing a Funct ion
T here are two ways to exit an option. Pressing BACK once returns to the previous menu
and saves any changes. Pressing CANCEL exits to the previous menu; however,
changes are not saved.
Sleep Delay
When the printer is idle for a selected period of time, it goes into sleep mode to conserve
power. Your System Administr at or can adjust the Sleep Delay setting. T he default setting
is 60 minutes. T he printer wakes from sleep mode when it receives a print job, a button is
pressed, or the printhead is opened or closed.
Select ing t he Pr int er ' s Language
T o change the printer's menu language:
1. Press MENU.
2. Press or until you see SETUP. Press SELECT.
3. Press or until you see LANGUAGE. Press CHANGE.
4. Press or until you see the language you need, then press SET.
5. Press BACK until you see " Ready," then press SELECT.
1-4 Operator's Handbook
network activity/rece ivi ng data
a connection is present
Gre e n LED
Ora nge LED
"Diagnostics &
MPCL
R EADY
0 00.0 .0. 000
FE E D TLA B E L M E N U