Kia Carnival Manual page 666

What to do in an emergency
4. Adjust the tyre inflation pressure
to the recommended tyre infla -
tion.
With the ignition switch or
ENGINE START/STOP button on
ON, proceed as follows.
To increase the inflation pres -
sure: Switch on the compressor.
To check the current inflation
pressure setting, briefly switch
off the compressor.
To reduce the inflation pres -
sure: Turn the valve on the
compressor.
CAUTION
Do not use the tyre sealant when
only the tyre pressure is adjusted.
WARNING
Do not let the compressor run for
more than 10 minutes, otherwise
the device will overheat and may be
damaged.
CAUTION
If the inflation pressure is not main -
tained, drive the vehicle a second
time, refer to "Distributing the seal -
ant" on page 7-33. Then repeat
steps 1 to 4.
Use of the TMK may be ineffectual
for tyre damage larger than
approximately 4 mm (0.16 in).
7 34
If you have a flat tyre (with tyre mobility kit)
We recommend that you contact a
professional workshop if the tyre
cannot be made roadworthy with
the Tyre Mobility Kit.
WARNING
The tyre inflation pressure must be
at least 180 kPa (26 psi). If it is not,
do not continue driving. Call for road
side service or towing.
NOTICE
When reinstalling the repaired or
replaced tyre and wheel on the vehi -
cle, tighten the wheel lug nut to 11 ~
13 kgf m (79 ~ 94 lbf ft).
Notes on the safe use of the Tyre
Mobility Kit
Park your car at the side of the
road so that you can work with
the TMK away from moving traf -
fic. Place your warning triangle in
a prominent place to make pass -
ing vehicles aware of your loca -
tion.
To be sure your vehicle will not
move, even when you're on fairly
level ground, always set your
parking brake.
Only use the TMK for sealing/
inflation passenger car tyres. Do
not use on motorcycles, bicycles
or any other type of tyres.