Care & Cleaning - Sage STM800 User Manual

CUSTOMISING BREW TIME
Brew time less than 10 minutes
Press the right ARROW UP button to
increase the time, or the right
DOWN button to decrease the time.
Manual mode-brew times
over 10 minutes
i) Press the right
increase the time up to the maximum 10
minutes.
ii) Continue to press the right
UP button. The LCD screen will display
'MANUAL LIFT' and '- - : - -' on the right
side of the LCD.
iii) Once the Tea Maker
the correct water temperature is reached,
the basket will automatically lower.
iv) Once the desired brew time has elapsed,
press and hold the BASKET button for 2
seconds. The basket will rise.
AUTO START FEATURE
1. Press and hold the AUTO START button
for 2 seconds.
2. To set the CURRENT TIME, press the
left ARROW UP button to increase
the time, or the left
button to decrease the time in 1 minute
increments.
3. To set the START TIME, press the right
ARROW UP button to increase the
time, or the right
button to decrease the time.
4. Once current time and start time are
programmed, press either the flashing
HOT WATER/Cancel or TEA/Cancel
button to select which feature you would
like to start at the programmed time.
10
ARROW
ARROW UP button to
ARROW
™
is activated and
ARROW DOWN
ARROW DOWN
5. Ensure that the Tea Maker
with:
a) Sufficient water in the glass jug and
tea leaves in the basket for the tea
brewing cycle or,
b) Sufficient water in the glass jug for the
water heating cycle.
NOTE
Insufficient water may discolour your
Tea Maker ™ base!
NOTE
The 'Auto Start' feature can be cancelled
anytime by pressing the AUTO START button.
Care & Cleaning
CLEANING THE GLASS JUG
1. After each use, empty the glass jug. Do
not allow brewed tea to stand overnight.
2. Wipe the interior of the glass jug with
a soft damp sponge or rinse with warm
water. Tea deposits will enhance the
flavour of the brewed tea, so if only
using as a Tea Maker
with soapy water.
3. Wipe the exterior of the glass jug with
a soft damp cloth to clean.
™
is prepared
™ do not wash