Care & Cleaning - Sage STM800BSS4EEU1 Quick Manual

Care & Cleaning
CLEANING THE GLASS JUG
1. After each use, empty the glass jug. Do
not allow brewed tea to stand overnight.
2. Wipe the interior of the glass jug with
a soft damp sponge or rinse with warm
water. Tea deposits will enhance the
flavour of the brewed tea, so if only
using as a Tea Maker
with soapy water.
3. Wipe the exterior of the glass jug with
a soft damp cloth to clean.
4. To remove the build-up of tannin,
the astringent chemical constituent of tea,
fill the glass jug with water up to the water
maximum mark (1500mL WATER MAX)
and bring water to boil and allow water
to cool for one minute. Add contents
of tea cleaner packet and allow to stand
for 5 minutes. Empty Tea Maker,
refill with fresh water and boil. Repeat
this step again. Empty Tea Maker
and rinse thoroughly.
5. Dry thoroughly with a soft lint-free cloth
before using.
NOTE
Allow all parts of the Tea Maker
cool completely before disassembling
and cleaning.
do not wash
™
™
™
to
™
NOTE
Only the jug lid, tea basket, tea basket lid
and tea scoop are dishwasher safe.
CLEANING THE JUG LID AND
INTEGRATED SCALE FILTER
1. Wash the jug lid in warm soapy water with
a soft sponge, rinse and dry thoroughly.
The integrated scale filter can be cleaned
by placing under running hot water and
rubbing with a cleaning cloth or brush.
2. Alternatively, the jug lid is dishwasher
safe. Position the jug lid vertically so the
scale filter is facing upwards. This will
allow water to drain properly.
3. Let all surfaces dry thoroughly prior
to using.
CLEANING THE TEA BASKET LID,
TEA BASKET AND TEA SCOOP
1. Wash the tea basket lid, tea basket and
tea scoop in warm soapy water with
a soft sponge, rinse and dry thoroughly.
A non-abrasive liquid cleanser or mild
spray solution may be used to avoid
build-up of stains. Apply the cleanser to
the sponge, not the accessory surfaces,
before cleaning.
2. Alternatively, these accessories are
dishwasher safe.
3. Let all surfaces dry thoroughly prior
to using.
CLEANING THE POWER BASE
4. Wipe the power base with a soft
damp sponge.
5. Let all surfaces dry thoroughly prior
to inserting the power plug into
a wall outlet.
EN
11