5
Simulation
sensor
5.1 Simulating Thermocouples
Connect calibrator input/output terminal to the instrument to be tested using
thermocouple. The connecting diagram is shown below, Proceed as follows to simulate
a thermocouple:
1.
Connect thermocouple to the TC input/output plughole of calibrator as shown in
Figure 5.1-1.
2.
If necessary, press
3.
Press
key to select thermocouple graduation.
4.
Press
or
5.
Press
to select output mode.
to select thermocouple function. If necessary, continue pressing the
to select temperature. Press
Figure 5.1-1
to display the DC mV value, which continue to display for 3s and
of
temperature
or
to select digit.
18