Table of Contents
Advertisement
4.2 Using Resistance Thermometer Detector
(RTD)
The calibrator accepts Pt100, Pt1000, Cu50 and Cu100, etc. The calibrator accepts
RTD measurements inputs in two-, three-, or four-wire connections, with the
three-wire connection the most common. A four-wire configuration provides the
highest measurement precision, and two-wire provides the lowest measurement
precision.
To measure temperature using an RTD input, proceed as follows:
1.
Press
2.
Press
Figure 4.2-1. If desired, continue pressing this key to select the desired RTD
type.
3.
Connect RTD to the corresponding port according to the connecting type of
'resistance measurement'.
to select
mode.
for the RTD display. Then the screen will display as shown in
Figure 4.2-1
17
Advertisement
Table of Contents
